On power-up, the alarm LED will rapidly flash red/green for 30 seconds to indicate that the device is booting.
Applying Powerįor the T300 and T550 mains powered models, apply power by inserting the supplied mains lead into the IEC inlet at the rear of the appliance and into an appropriate AC power source.įor the T100 DC powered model, apply power by plugging the supplied power adapter into the appliance and into an appropriate AC power source.
Installing timetool Patch#
Connect an Ethernet cable to the network connector on the rear of the appliance and to a network hub or switch.Īlternatively, for configuration purposes, the appliance can be connected, peer-to-peer, directly to a host PC network port using a patch cable. The T-Series has either one or two 10/100MBit RJ45 network connections. The TNC connectors on the antenna and appliance should be fully screwed home, but do not over-tighten. Antenna CablingĬonnect the supplied coax cable to the GPS\GNSS antenna and to the antenna connector at the rear of the appliance. The supplied antenna mount can be used to fix the antenna to a wall or vertical surface or to a mast using the supplied V-bolt. Alternatively, indoor operation is sometimes possible, providing the building is not metal clad or metal framed. However, adequate signal reception can often be obtained with an antenna located on the side of a building or in a window. Ideally, a GPS\GNSS antenna should be positioned in a location where the top of the antenna has a clear view of the sky. It should not be supported by the attached cables. Locate the device in a rack, on a shelf, or in a cupboard.
TimeTools T-Series NTP server appliances should only be installed indoors.
0 kommentar(er)
